•	Synchronize the speed between Pay off and Take up units.
•	Touch screen (MMI) easily control machine overall movement.
•	Standard service range from Coil O.D. 80-800mm.

•	Auto coiling wire from an extrusion line or from a pay off rewinding line.
•	Touch screen (MMI) easily control machine overall movement.
•	Standard service range from Coil O.D. 80-800mm.

 

•	Design for request of high speed and big bobbin sizes.

•	Cantilever type motorized Pay off & Take up machine.
•	2 AC motors drive the arms to open and close to lock or release the drum.
•	A pair of hydraulic cylinder to raise up and lower down the drum.

•	HMI & PLC control systems for speed synchronization with the line.
•	High precision cable traversing completed by servo motor.

•	The machine can wind the cable onto the plastic/cardboard/polywood reel.
•	Traversing type: bobbin traversing / shaft traversing.
•	Also available to make cable coil with optional collapsible reel.

•	The spooler equips with a length counter, safety cover, cable cutter, and optional pvc film wrapping unit.
•	Single spooler is available upon request.

•	Movable cover at coiling unit provides a better working safety.

 

•	Instant generated sparks will not damage the cables.

•	High frequency detection can be very sensitive and rapid detect pinhole, cable with damaged coating, and cable conductor faulty.

•	Electrical conductors after failure detection can quickly restore dectection status (about 0.1 sec.).

 

•	Vertical type wire pre-heating.
•	Speed can be synchronized with capstan in extrusion line.
•	Equipped wtih inlet and outlet pulley to guide the wire properly.

•	High efficiency and low consupmtion.
•	The wire and cable pass through this machine with little resistance to avoid stretch.